16ft Power Mill Article

JBarker · Post by **JBarker** » Mon Jun 05, 2023 10:37 am

http://www.newparkwindengine.com/1888-aermotor/

mtblah · Post by **mtblah** » Mon Jun 05, 2023 8:36 pm

Jerry , thank you for posting , very interesting .

Windcatcher530 Dan · Post by **Windcatcher530 Dan** » Mon Jun 05, 2023 8:58 pm

Jerry is there a close photo of that mill especially the Hub? The photos I saw years ago are questionable, but that was when I was green.

Kansas Rust Buzzard · Mon Jun 05, 2023 10:22 pm

too bad they made the vid private, it was the best part!

Kevin · Post by **Kevin** » Mon Jun 05, 2023 10:23 pm

It is a Bell Hub Aermotor Power Mill beautifully restored.
I really enjoyed seeing and hearing it run when I was there is 2017.

Windcatcher530 Dan · Post by **Windcatcher530 Dan** » Tue Jun 06, 2023 5:38 am

Okay thanks Kevin I didn't think it was an original 88 or 89.

JBarker · Post by **JBarker** » Tue Jun 06, 2023 7:01 am

Windcatcher530 Dan wrote: ↑Mon Jun 05, 2023 8:58 pm Jerry is there a close photo of that mill especially the Hub? The photos I saw years ago are questionable, but that was when I was green.

not that I could find

Wayne · Post by **Wayne** » Tue Jun 06, 2023 8:51 am

Did I miss something? Where is it located?

Windcatcher530 Dan · Post by **Windcatcher530 Dan** » Tue Jun 06, 2023 9:07 am

Wayne I believe Pennsylvania.

mtblah · Post by **mtblah** » Tue Jun 06, 2023 12:20 pm

south easten side , near the Virginia border

Vintage Windmill and Wind Generator Forum

16ft Power Mill Article

16ft Power Mill Article

Re: 16ft Power Mill Article

Re: 16ft Power Mill Article

Re: 16ft Power Mill Article

Re: 16ft Power Mill Article

Re: 16ft Power Mill Article

Re: 16ft Power Mill Article

Re: 16ft Power Mill Article

Re: 16ft Power Mill Article

Re: 16ft Power Mill Article