Page 9 of 12
Re: new in Canada
Posted: Sun Jan 21, 2024 3:54 pm
by Peter vk
Getting the old cups out is usually the hard part
Re: new in Canada
Posted: Fri Jan 26, 2024 4:25 pm
by jerryd
Hello all,
Had an hour so removed old bearing cups and set the new in. Used some heat. outer was slow to give in but rear with heat 10 minutes. cleaned up seat. They are tight going in. No lock tight needed. nothing cracked
Re: new in Canada
Posted: Sun Mar 03, 2024 9:26 am
by jerryd
Morning,
What is the diameter of the Beatty oil return hub?
And what wear tolerance is acceptable?
Thanks for your help
jerry
Re: new in Canada
Posted: Mon Mar 04, 2024 6:53 pm
by wind fab
jerry
looks good to me no noticeable wear
paul south of hamilton on
Re: new in Canada
Posted: Fri Mar 08, 2024 7:48 am
by jerryd
Morning
For the Beatty windmill- What grade of steel balls are required? I see some are slingshot quality and have seen some up to $30 each. Yikes.
Thanks for the help
jerry
Re: new in Canada
Posted: Mon Mar 11, 2024 6:46 pm
by jerryd
Morning
For the Beatty windmill- What grade of steel balls are required? I see some are slingshot quality and have seen some up to $30 each. Yikes.
Thanks for the help
jerry
Re: new in Canada
Posted: Mon Mar 11, 2024 7:11 pm
by Peter vk
I just get them on Amazon, good quality. Not the ones for slingshots
Re: new in Canada
Posted: Tue Mar 12, 2024 5:08 am
by jerryd
Thankyou
Will get them ordered
Re: new in Canada
Posted: Sat Mar 23, 2024 6:49 pm
by jerryd
Evening all,
Couple of questions for the Beatty fans.
How do you patch bullet holes? Like this one in the hood of my Beatty mill cap.
Can this Beatty pump be identified by year? It works and we use it. It is our water pump when power is off. Had it in the basement for 40 years and finally set it up 4 years ago
And my seven year old granddaughter uses it often watering grammas' flowers. She will pump and carry 6 or more buckets. Says she is a farmer girl.
Re: new in Canada
Posted: Sun Mar 24, 2024 7:16 am
by jerryd
/